
TPO Roofing
White single-ply membrane with hot-air welded seams, fitted to warehouses, cold storage, and offices where a reflective roof and welded laps around rooftop units matter most.
TPO Roofing in Enfield
As an Enfield commercial roofing contractor, we install, replace, and repair TPO, EPDM, and metal roofs on warehouses, plants, offices, and shops in north-central Connecticut.
Every Enfield commercial roofing job starts with what the core cuts and the roof walk show. The condition of the deck and insulation decides which of these three paths fits.
Every job follows the same work order, from the first roof walk to the final walk-through with your facility manager.
We walk the roof with you, look at seams, flashings, drains, and rooftop units, and take core cuts where the membrane or deck looks suspect. Inside, ceiling stains and wet tiles are matched to what we find above.
Findings decide the path: repair, recover, or tear-off, and which membrane or panel fits the deck, slope, insulation, and equipment. You get the scope in writing, with the price and the details it covers.
Staging, dumpsters, crane picks, and dock access get mapped before the crew arrives. Loud tear-off is timed around shipping and production, and rooftop unit shutdowns are set with your mechanical contractor.
Crews open only the area they can close watertight before they leave, then install insulation, membrane, and flashings at curbs, walls, and drains. Seams are welded or taped and checked before a section is closed.
At the end, we walk the new roof with you, probe welded seams, run water to the drains where we can, and hand over a record of what was installed and where.
Four roof systems cover nearly every low-slope and metal roof in town. Each tile says where that system fits.

White single-ply membrane with hot-air welded seams, fitted to warehouses, cold storage, and offices where a reflective roof and welded laps around rooftop units matter most.
TPO Roofing in Enfield
Black rubber membrane that stays flexible through Connecticut winters, laid fully adhered or ballasted over insulation on older low-slope roofs and additions.
EPDM Roofing in Enfield
Membrane and metal roofs for plants and distribution centers, with every fan, duct, and curb flashed into the new roof and walkway pads on service paths.
Industrial Roofing in Enfield
Standing seam and exposed fastener panels for shops, storage buildings, and tobacco sheds, installed new or over an existing roof once the framing is checked.
Commercial Metal Roofing in EnfieldCall and tell us where the water shows up inside. We start with the roof area above it and the drains nearby.
Send the property address and a line about the roof. We set up a roof walk and core cuts before pricing the job.
Get A Free EstimateA planned replacement fixes the problems that keep facility managers climbing ladders with buckets every spring.
Wet boards found by core cuts come out, so the roof insulates again and the steel deck stops rusting under trapped moisture. That alone ends many winter ceiling stains.
Membrane laps are hot-air welded on TPO or taped on EPDM and checked before each section closes, so seams hold at the corners and curbs where leaks used to start.
New drain sumps, clamping rings, and tapered insulation at low spots carry snowmelt to the drains instead of letting it pond and refreeze against the parapet.
Curbs, walls, and pipe boots get new flashing tied into the membrane, raised where added insulation makes the roof thicker, so rooftop units sit on dry, sealed bases.
Most roof problems show up indoors first. Each pair links what staff see inside to what we usually find above it.
Ceiling tiles darken along one wall a day or two after snowmelt, then dry out until the next thaw.
Ice at the parapet has pushed water under the wall flashing or a lifted seam at the base of the wall.
Water drips near diffusers or ductwork under a rooftop unit, mostly during heavy rain.
The curb flashing has split or pulled loose, or the unit's condensate line drains onto an open lap.
Stock rooms smell damp and one bay feels colder than the rest, with no single drip to point at.
Wet insulation under the membrane, usually around a clogged drain where water has pooled for years.
Each repair stops one drip and another starts a few bays over within a season.
Seams are failing across the whole roof, a sign the membrane is near the end of its service and patching is chasing it.
Is your building near Enfield? We install and repair commercial roofs across the towns below; for anywhere else, call us or send us a message.
Short answers to what owners and facility managers ask most before a roof replacement.
There is no fixed number of years. Service life depends on the system, the quality of the installation, how well water drains, how much foot traffic the roof takes, and how often freeze-thaw cycles work at its seams. Inspections and quick repairs keep any roof in service longer.
More roofing questionsEither can work on a low-slope roof. TPO is a white sheet with welded seams that reflects summer sun, and EPDM is black rubber with taped seams that stays flexible in the cold. The deck, insulation, rooftop equipment, and the roof already there usually settle it.
Roof size, the system chosen, and how many old layers come off set most of the price. Deck repairs, wet insulation, the number of curbs and drains, and crane or staging access add to it. We price each roof after measuring it and taking core cuts.
Ask each one to walk the roof before quoting and to write down the scope: tear-off or recover, insulation, flashings, and drains. Then look up the contractor's Connecticut registration on the state eLicense lookup, which Enfield's Building Inspection department points owners to.
In most cases, yes. We work in sections, open only what can be closed watertight before the crew leaves, and line up refrigeration shutdowns with your mechanical contractor so units come off and go back on in order.
The roofing contractor usually pulls it. Enfield's Building Inspection department, at 810 Enfield Street next to Town Hall, takes permit applications online, and its permit exemption list for commercial buildings is worth a look before the job is scheduled.
Send the property address for a roof walk and a written scope, or call to talk through a leak you are dealing with now.