Drips In A Line Across The Floor
Water drips in neat rows under the roof during rain, landing on stored equipment or crops.
Fastener washers have cracked and screws have backed out, so each hole lets water through.

As a Suffield commercial roofing contractor, we install metal roofs on tobacco sheds, barns, and storage buildings, and replace flat roofs on shops and offices in town.
Suffield commercial roofing often means metal panels on long farm buildings: tobacco sheds, equipment barns, and storage built on open framing. These roofs carry snow, see wind across open fields, and need air moving under the panels to keep condensation down.
We check purlins, rafters, and ventilation before choosing panels. Rotted framing gets fixed first, and the panel profile, fasteners, and underlayment are matched to how the building is used.

Farm and storage roofs fail in ways you can spot from the floor. These pairs show the usual cause.
Water drips in neat rows under the roof during rain, landing on stored equipment or crops.
Fastener washers have cracked and screws have backed out, so each hole lets water through.
The underside of the panels is wet on cold mornings even when it has not rained.
Warm, moist air is condensing on cold metal because the building has little ventilation or underlayment.
Light shows through small holes near the eaves, and rust stains run down the walls.
Panel laps near the eave have held snowmelt for years and the steel has rusted through at the bottom edge.
Snow drops off the roof onto a sliding door or walkway after every storm.
The panels have no snow guards above the door, so the whole slope lets go at once.
A new metal roof on a shed or barn solves the problems that keep coming back on an old one.
Every screw is new, with a sealing washer set at the right depth, so the rows of drips under worn fasteners stop.
Underlayment or vapor control and planned ventilation keep moist air off the cold steel, so stored goods stay drier on cold mornings.
Panels with sound laps and trim shed snow and rain on sloped roofs, and snow guards go over doors and walkways where sliding snow would land.
Rotted purlins and rafters are replaced or sistered first, so new panels sit on solid supports and fasten straight.
Most Suffield work is metal, with membrane roofs on the town's shops and offices.

Exposed fastener panels suit storage and farm buildings, and standing seam fits shops where concealed clips are worth the added cost.
Commercial Metal Roofing details
Flat-roofed shops and offices in town take welded TPO, which reflects summer heat away from the space below.
TPO Roofing details
Low additions on older buildings take rubber membrane, which bends well where the addition meets a taller wall.
EPDM Roofing details
Processing and packing buildings with fans and equipment get industrial membrane roofs flashed around every unit.
Industrial Roofing detailsCall and tell us which building and where the water lands. Fasteners and laps are the first things we check.
Send the address and the size of the building. We look at the framing before quoting panels.
Get A Free EstimateFarm roof jobs run around harvest, storage, and equipment moves.
We walk the roof or check it from a lift, look at fasteners, laps, and trim, and go inside to check purlins, rafters, and signs of condensation.
Panel profile, gauge, color, fasteners, and underlayment are chosen for the building and its use, and the written scope lists every piece.
Stored crops, equipment, or hay get covered or moved where old panels come off, and the crew works around your seasonal schedule.
Old panels come off in runs, framing is repaired, and new panels are fastened and trimmed at the ridge, eaves, and gables.
Once trim and snow guards are on, we walk the roof and the inside of the building with you and note anything to watch next winter.
Is your property just past the town line? We also roof in the towns below; for anywhere else, call us or send us a message.
What Suffield farm and business owners ask before a roof job.
Yes. We install and replace metal roofs on tobacco sheds, barns, storage buildings, and shops in Suffield, including exposed fastener and standing seam panels. On existing metal roofs we replace damaged panels and worn fasteners, and we check ventilation before choosing panels.
More roofing questionsSometimes. New panels can go over old ones on purlins or furring when the framing carries the added weight and the old roof is dry. Rusted-through panels and rotted framing usually mean the old roof comes off first.
Condensation forms when warm, damp air meets cold steel. We add underlayment or a vapor control layer under the panels and plan airflow at the ridge and eaves, so less moisture reaches the metal.
Coated screws with sealing washers, set snug without crushing the washer, last longest on exposed fastener panels. We replace every screw on a reroof rather than reusing old holes.
Most of the time goes into framing repairs and trim. A simple storage building can be roofed in a few days once materials arrive, while long sheds with rotted purlins take longer.
Send the property address and tell us which buildings need roofs, or call about a leak in a shed or barn.